What Does h335 vs cfe223 Mean?

What Does h335 vs cfe223 Mean?

Blog Article

Make sure you clean any jacket fouling out of your barrel prior to deciding to shoot TSX Bullets. We've discovered that jacket fouling diminishes accuracy with our bullets.

It really is anecdotal, but for what its worthy of when comparing wc844 to tac both of those loaded to 5.56 pressures in a very eleven.5 barrel, WC844 can make some good fireballs in which with tac it is nearly non-existant. Offered in which tac and h335 fall over the burn up rate chart I might have considered it might have been the alternative.

If on the lookout to obtain an automatic powder-cost dispensing unit to speed up precision reloading, You should not judge the RCBS ChargeMaster Lite powder scale and dispenser by its title; the Minimal Eco-friendly machine packs a large-weight punch with speed and accuracy.

Scott Rupp will get a chance to talk with Aaron Oelger a couple of few new products from Hodgdon and why reloading store cabinets are empty.

I have applied BLC two For some time. Just Will not depart your ammo out while in the Sunshine for several hours if It can be very hot outside.

Mainly what I am seeking and doubtless diddn't say it very well Is that this. If my max load for regular bullets is 42 gr od H335 then what could possibly my max load be Along with the exact same powder and moly bullets. Hoping to compare apples with apples.

This is an older thread, you may not get a response, and will be reviving an old thread. You should contemplate developing a new thread.

I have also found powder lot numbers fluctuate ample to bump pressures to unwanted ranges. Once again, approach utmost loads with caution. It is additionally noteworthy when using spherical powders not to further reduce the “commence” loads, or erratic ignition and Odd pressures can happen.

But I've many H335 and am endeavoring to get it to shoot as exact as being the CFE223 powder. Has any one chronoed CFE223 loads with fifty five gr bullets that could article the results ?   rebs

I browse it somewhere on that site concerning the TTSX and XTB. I have never identified any CFE-223 data any place else. I will probably read more be happy in the event the data makes it towards the paper manuals!

wondering if any individual has viewpoints on which powder would be much better to employ and why. I exploit cfe223 in several loads and possess lots of it. I've 2 lbs . of H335 and don’t utilize it in anything still.

I burn plenty of H-335 in my AR's, but the loads were labored up during the summer time and are burnt over the summertime.

Gunshop didn't have the powder I used to be looking for but a pound of this identified as out my identify and I took it house the opposite day.

Getting new to reloading, I just utilized the rookie Lee .223 die set and trim using a hand drill as well as the Lee circumstance length gauge with the cutter.